User Manual

ManualsBrandsFujitsu ManualsCell PhonesFujitsu F-01A Cellular Phone

Before Using the Handset

F-01A_E1kou

Summary of content (21 pages)

PAGE 1
F-01A_E1kou F-01A.book Page 41 Tuesday, September 2, 2008 6:34 PM i Other Document Display "Other" in Data Box. [Exit] : Exit the function and return to flip menu ･ Menu items other than common menus differ depending on functions.
PAGE 2
F-01A_E1kou F-01A.book Page 42 Tuesday, September 2, 2008 6:34 PM ■ Channel switch (while watching 1Seg)/volume adjustment (while watching 1Seg, playing video, playing movie/i-motion) ･ Slide right or left on the screen and touch or on channel switch panel. ･ Slide up/down on the screen or touch [Volume] on operation menu, and touch or on volume adjustment panel.
PAGE 3
F-01A_E1kou F-01A.book Page 43 Tuesday, September 2, 2008 6:34 PM ■ While displaying My Document (PDF data)/Other Document (other data) ･ From operation menu, [Zoom In], [Fit page], [Zoom Out] and [<< Jump]/[Jump >>] (move by 10% of the whole page) are available. ･ From submenu, [Fit page], [Fit width], [First page], [Last page] and [Rotate-right] are available. ･ While displaying My Document (PDF data), [Actual size] is available on submenu.
PAGE 4
F-01A_E1kou F-01A.book Page 44 Tuesday, September 2, 2008 6:34 PM ◆ Using Multitask menu in flip style In flip style, press M (1 sec. or more) to display menu. From the menu, you can select from 4 functions of Silent mode ON, IC card settings, Saving mode ON/OFF and Screen OFF. ･ Some functions cannot be performed at the same time with the function in use. ･ If you touch [Screen OFF], the screen light turns off and touch operations become unavailable.
PAGE 5
F-01A_E1kou F-01A.book Page 45 Tuesday, September 2, 2008 6:34 PM ◆ Setting the effective area or sensitivity of pointing device [Settings & NW services] 77eSet the required 1m itemseC Use sensor for: : Set the effective area for pointing device. ･ When setting to "F-browser/i-αppli", pointing device can be used only for Full Browser and i-αppli. ･ If setting to "Not use", fingerprint sensor is available only for fingerprint authentication.
PAGE 6
F-01A_E1kou F-01A.book Page 46 Tuesday, September 2, 2008 6:34 PM ✔INFORMATION ･ Depending on the spot or strength you tap, the alarm may not stop. And, note that tapping too strongly may cause malfunction. ･ While walking or in the place with much vibration, operations to stop alarm sound by ■ Installing a Pull the tab and pull out the tray until it clicks. b Hold UIM with the IC side up, align the beveled corner with the tray and push into the tray until it stops.
PAGE 7
F-01A_E1kou F-01A.book Page 47 Tuesday, September 2, 2008 6:34 PM ◆ UIM operation restriction ◆ Settings when replacing UIM FOMA terminal is provided with UIM operation restriction for protecting your data/ files or data/files copyrighted by a third party. ･ When files or data are downloaded from websites or data attached to mails are obtained to your FOMA terminal with UIM equipped, UIM operation restriction is automatically set to these data or files.
PAGE 8
F-01A_E1kou F-01A.book Page 48 Tuesday, September 2, 2008 6:34 PM ◆ UIM types When using UIM (blue) in FOMA terminal, note that it differs in the items listed below from UIM (green/white). Page ･ After turning power OFF, fold FOMA terminal and hold it in your hand. ･ Removing battery pack may cause reservation of Software update to be canceled. P86 When the date and time are set with Auto time adjust set to "OFF" in Date & time, removing battery pack may delete date and time.
PAGE 9
F-01A_E1kou F-01A.book Page 49 Tuesday, September 2, 2008 6:34 PM c With the label side of the battery pack upward, place the convex part of the battery pack to the concave part of FOMA terminal and plug in the direction of a, and fit it in by pressing in the direction of b and close the inner lid. e Slide the lever of back cover in the direction of the arrow to lock. Lever Convex part Battery Pack Concave part ■ Removing a Perform the procedure a-b of Installing.
PAGE 10
F-01A_E1kou F-01A.book Page 50 Tuesday, September 2, 2008 6:34 PM ❖ For better battery pack performance ❖ Operation time on full charge (approximate) ･ Do not charge the battery for an extended period (several days) with FOMA The times below vary by the charging method and operating environment. terminal turned ON. After charging has completed with FOMA terminal turned ON, the power is supplied to the terminal from the battery pack.
PAGE 11
F-01A_E1kou F-01A.book Page 51 Tuesday, September 2, 2008 6:34 PM ❖ Battery charge ･ For details, refer to the operation manuals for FOMA AC Adapter 01/02 (optional), FOMA AC Adapter 01 for Global use (optional) or FOMA DC Adapter 01/02 (optional). ･ FOMA AC Adapter 01 is applicable only to 100V AC. Though FOMA AC Adapter 02 and FOMA AC Adapter 01 for Global use is applicable to 100-240V AC. ･ AC Adaptor has a plug dedicated to 100V AC (for domestic use).
PAGE 12
F-01A_E1kou F-01A.book Page 52 Tuesday, September 2, 2008 6:34 PM ■ Charging the battery using AC adapter only a Open jack cap (a) of FOMA terminal, hold the connector horizontally with the arrow side upward and insert it to the jack. (b) b Unfold the power plug and insert it into a 100V AC outlet. c When charging is over, pull out the power plug from the outlet, and pull out from FOMA terminal horizontally while pressing the release buttons on both sides of the connector.
PAGE 13
F-01A_E1kou F-01A.book Page 53 Tuesday, September 2, 2008 6:34 PM Remaining battery level Power ON/OFF Checking remaining battery level Turning power ON/OFF A battery icon appearing on the top of the display shows an approximate remaining battery level. (Battery level 3) : Ample charge. (Battery level 2) : Low charge. (Battery level 1) : Very low. Charge the battery. ･ The battery icon set by default varies by the color of FOMA terminal.
PAGE 14
F-01A_E1kou F-01A.book Page 54 Tuesday, September 2, 2008 6:34 PM ◆ Operations to perform after turning the power ON at the first time When turning the power ON for the first time, operate in the order of "AdvancedMode setting"→"Initial setting". The settings made can be changed later. ･ When initialization is finished, a confirmation screen of software update function appears. Press g to display the stand-by screen.
PAGE 15
F-01A_E1kou F-01A.book Page 55 Tuesday, September 2, 2008 6:34 PM Select language Switching to English You can select language from Japanese or English (Select language). 1 m [Settings & NW services] 263e1 or 2 ✔INFORMATION ･ This setting is also saved to UIM. ･ Even if setting to "English", the displayed menu is not switched to English in some Kisekae Tool. Note that, when Kisekae Tool in "Preinstalled" folder is set, a menu dedicated to "English" is displayed.
PAGE 16
F-01A_E1kou F-01A.book Page 56 Tuesday, September 2, 2008 6:34 PM Caller ID notification User information Notifying your phone number to the other party Checking your own phone number You can set FOMA terminal to display your number (Caller ID) on the other party's terminal when making a voice call, videophone call or PushTalk call. ･ For details, refer to "Mobile Phone User's Guide [Network Services]". ･ Caller ID is your important information.
PAGE 17
F-01A_E1kou F-01A.book Page 464 Tuesday, September 2, 2008 6:34 PM Specific Absorption Rate (SAR) ◆ SAR certification information This model phone FOMA F-01A meets the MIC's*1 technical regulation governing exposure to radio waves. The technical regulation established permitted levels of radio frequency energy, based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies.
PAGE 18
F-01A_E1kou F-01A.book Page 465 Tuesday, September 2, 2008 6:34 PM ◆ Federal Communications Commission (FCC) Notice ･ This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions : a this device may not cause harmful interference, and b this device must accept any interference received, including interference that may cause undesired operation.
PAGE 19
F-01A_E1kou F-01A.book Page 466 Tuesday, September 2, 2008 6:34 PM * In the United States and Canada, the SAR limit for wireless mobile phones used by the general public is 1.6 Watts/kg (W/kg), averaged over one gram of tissue. SAR values may vary depending upon national reporting requirements and the network band. For other Medical Devices : Please consult your physician and the device manufacturer to determine if operation of your phone may interfere with the operation of your medical device.
PAGE 20
F-01A_E1kou L025.fm Page 467 Thursday, September 4, 2008 2:48 PM ◆ Trademarks Company and product names mentioned in this manual are trademarks or registered trademarks of their respective holders.
PAGE 21
F-01A_E1kou F-01A.book Page 468 Tuesday, September 2, 2008 6:34 PM ･ Bluetooth® and its logo are registered trademarks of Bluetooth SIG, Inc., and NTT ･ This product is licensed based on MPEG-4 Visual Patent Portfolio License. The use DOCOMO uses them under license. Other trademarks and names inhere to their respective owners. Napster is a registered trademark of Napster, LLC. and/or its affiliates in the US and/or other countries. Google is registered trademark of Google Inc.