Operation Manual

Wichtige Hinweise

FCC Compliance S tatement

If the device complies with the FCC regulations, the FCC sign can be found on the type rating plate.

FCC Class B Compliance State

ment

The following statement applies to the products covered in this manual, unless otherwise speciﬁed

herein. The statement for other products will a ppear in the accompanying documentation.

NOTE:

This equipment has been tested and found to comply with the limits for a "Class B" digital

device, pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian

Interference-Causing Equipment Standard ICE S-003 for digital app aratus. These limits are

designed to provide reasonable protection against harmful interference in a r esidential installation.

This equipment generates, uses and can radiate r adio frequency ene rgy and, if not installed

and used in strict accordance with the instructions, may cause h armful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or t elevision r ece ptio n,

which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the sep

aration between equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult the de

aler or an expe rienced radio/TV technician for help.

Fujitsu Technology Solutions Gm bH is not responsible for any radio or television interferen ce

caused by unauthorized modiﬁcations of this equipment or the substitution or attachment

of connecting cables and equipment other than those speciﬁed by Fujitsu Technology

Solutions GmbH. The correction of interferen ces caused by such unau thorized modiﬁcation,

substitution or attachment will be the resp onsibility of the user.

The use of shielded I/O cables is required when connecting this equipment to any and all optional

peripheral or host devices. Failure to do so may violate FCC and ICES rules.

10 Fujitsu Technology Solutions