Operation Manual

System expansio ns
Installing an acce ssible 3
1
/
2
inch d rive (floppy disk drive or multicard
reader) or a non-accessible 3
1
/
2
inch drive (hard disk)
► Remove the cover (see chapter "Removing a cover " , Page 33).
► Remove the front panel (see chapter "
Removing the front panel", Page 34).
► Remove the drive cover if one is fitted. To do this, press the corresponding drive cover
lightly out forwards and pull the drive cover forward out of the fro nt panel.
► Remove the drive cage (see chapter "
Removing the drive carrier", Page 37).
► Turn the drive cage over.
1
2
2
2
► Slide the drive into the casing (1). Make sure that the screw holes of the
drive cage and of the drive are aligned.
► Fasten the drive into place with the screws (2).
► Install the drive cage (see chapter "
Installing the drive ca ge", Page 38).
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Secure the front pane l on the casing (see chapter "
Securing the front p anel", Page 35).
► Install the cover on the casing again (see chapter "
Reattaching the cover", Page 36).
It may be necessary to modify the entry for the drive in the BIOS Setup.
Fujitsu Technology Solutions 43