Operation Manual

System expansio ns
Installing an accessible 5
1
/
4
inch drive (e.g. DVD drive)
► Remove the cover (see chapter "Removing a cover " , Page 33).
► Remove the front panel (see chapter "
Removing the front panel", Page 34).
► Remove the drive cover if one is fitted. To do this, press the corresponding drive cover
lightly out forwards and pull the drive cover forward out of the fro nt panel.
Do not throw away the covers. If you remove the drive again, you must reinstall the
covers (cooling, fire protection or EMC regulations to be complied with).
EMC,electrom agneticcompa tibi lity
► Remove the drive cage (see chapter "R emoving the drive carrier", Page 37).
► Turn the drive cage over.
► Take the new drive ou t of its packaging.
1
2
2
2
► Slide the new drive into the drive cage (1) until the stop. Make sure that the screw
holes of the drive cage and of the drive are aligned.
► Fasten the screws (2).
► Install the drive cage (see chapter "
Installing the drive ca ge", Page 38).
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Secure the front pane l on the casing (see chapter "
Securing the front p anel", Page 35).
► Install the cover on the casing again (see chapter "
Reattaching the cover", Page 36).
It may be necessary to modify the entry for the drive in the BIOS Setup.
Fujitsu Technology Solutions 41