Operation Manual

System expansions
Removing an accessible 5
1
/
4
inch drive (e.g. DVD drive)
► Remove th e cover (see chapter "Removing a cover", Page 33).
► Remove the fro nt panel (see chapter "
Removing the front pan el", Page 34).
► Remove the drive cage (see chapter "
Removing the drive carrier", Page 37).
► Turn the drive cage over.
2
1
1
1
► Undo the screw s (1).
► Pull the drive out of the drive cage in the direction of the arrow (2).
► If necessary, m ake the required settings on the remaining hard disk drives.
► If you are not planning to install a new drive, install the corresponding drive cover in
the front panel (if available). To do this, insert the drive cover from behind into the front
panel and press the latches gently into their respective retainers.
► Install the drive cage (see chapte r "
Install ing th e drive cage", Page 38).
► Secure the front panel on the casing (see c hapter "
Securing the front p anel", Page 35).
► Install the cover on th e casing aga in (see chapter "
Reattaching the cover", Page 36).
It may be necessary to modify the entry for the drive in the BIOS Setup.
40 Fujitsu Technology Solutions