Operation Manual

Getting started

Gettingstarted

Please observe the safety information in the "Important notes", Page 7 chapter.

Unpacking and checking the delivery

It is recommended not to throw away the original packaging material! It may be

required for reshipment at some later date.

PackagingContentsofdeliveryPackaging,

► Unpack all the individual parts.

► Check the contents of the package for any visible damage caused during transport.

► Check whether the delivery conforms to the details in the delivery no te.

► Should you discover that the delivery does not correspond to the delivery

note, notify your local sales outlet immediately.

Steps for initial s etup

Preparingforﬁ rstuse, overviewPreparingforu se,

Only a few steps are necessary to put your new device into operation f or the ﬁrs t time:

• Select a location for device and set up device

• Connecting external devices

• Check the voltage a t the mains outlet and connect the device to an electrical outlet

• Switch the device on

You will learn more about the individua l steps in the following sections.

External devices

If you have received other external devices in addition to your own device ( e.g.

a printer), do not co nnect these until after the initial installation. The following

sections describe how to connect these external devices.

Drives and b oard s

If you have received drives or boards with your device, please do not install

them until after ﬁrst-time setup. How to install drives and bo ards is described

in the "

System expansions", Page 31 chapter.

12 Fujitsu Technology Solutions