Operation Manual

System expansio ns
Installing/removing a SmartCard reader (optional)
Operation of this module is not pe rmitted in Taiwan.
In systems equipped with a SmartCard reader, access can be restricted to those
users who have a corresponding SmartCard.
Installing the SmartCard reader
SmartCardread er
► Open the casing (see "Opening the casing", Page 34).
► Break out the w eb at the SmartCard opening on the fron t cover.
2
2
1
► Remo ve the drive cage (see "Removing
the drive cage", Page 37)
► Slide the SmartCard reader into the
bay provided for it (1) and secure it
with the two screws (2).
► Make sure that the SmartCard re ader
is also between the two brackets.
Otherwise, yo u will not be able to insert
the SmartCard from outside.
► Connect the cable for the SmartCard reader to the mainboard and the SmartCard
reader. Refer to the manual for the mainboard.
► Install the drive cage again (see "
Installing the drive cage", Page 38).
► Close the casing (see "
Closing the casing" , Page 35).
Removing the SmartCard reader
SmartCar
dreader
► Open the ca
sing (see "
Opening the casing", Pag e 34).
1
1
2
► Remo ve the drive cage (see "Removing
the drive cage", Page 37)
► Disconn
ect the SmartCard conn ector
from the
mainboard. Refer to the
manual
for the mainboard.
► Loosen the screws (1).
► Pull th
e SmartCard reader out of the bay (2).
► Install the drive cage again (see "
Installing
the drive ca ge", Page 38
► Clos
e the casing (see "
Closing the
casi
ng", Page 35).
Fujitsu 45