Operation Manual

System expansio ns
Removing the WLAN module
► Open the casing (see "Opening the casing", Page 34).
► Remove the dri ve cage (see "
Removing the drive ca ge", Pa ge 37).
► Disconnect the USB cable of the WLAN module from the connector on t he
mainboard. Refer to the manual for the mainboard.
1
1
2
► R e m ove the screws (1).
► Pull the WLAN modu le out of the bay (2)
together with the USB cable.
Make sure that you do not scratch the antenna on the front opening of the drive cage.
► Install the drive cage again (see "
Installing the drive cage", Page 38).
► Close the casing (see "
Closing the casing" , Page 35).
Installing an
d removing a board
Please read the section "Notes on boards".
You can only install low-profile boards.
To install a board please follow the steps below.
• Opening the retaining clip for the bo ard
•Instal
ling a board
• Closing the retaining clip
You wi
ll learn more about the individual steps in the following sections.
Fujitsu 47