Operation Manual

System expansions
Installing the drive cage
Drivecage
► O pen the casing (see "Opening the casing", Page 34).
2
1
► Push the drive cage at an angle into
the c asing mou nts (1).
► If a drive is present, connect the connector
of the data and power supply cables (2).
► Close the drive cage.
► Close the casing (see "
Closing the
casing", Page 35).
Installing and removing the accessible 5
1
/
4
inch drive
Removing an accessible drive
► O pen the casing (s
ee "
Opening the casing", Page 34).
► Remove the drive cage (see "
Removing the drive cage", Page 37).
1
1
1
2
► Remove the screw
s from the drive cage (1).
► Takethedriveoutofthedrivecage(2).
► Install the dri
ve ca ge again (see "
Install ing
the drive cage
", Page 38).
► If you do not want to install a new drive, you
must refit the plastic drive cover again (see
"
Installing the plastic d rive cover", Page 37).
► C lose the c
asing (see "
Closing the casing" , Page 35).
38 Fujitsu