Operation Manual

Troubleshooting and tips

Refer to the safety notes in the "Safety/regulations" manual and in th e "Getting

started", Page 11 chapter when connecting or disconnecting cables.

If a fault oc c u rs, try to c

orrect it as described in the following documentation:

• in this chapter

• in the documentation for the connected devices

• in the help systems of th

esoftwareused

• in the documentation for your operating system

Help if problems occur

Should you e ncount

er a problem with your computer that you cannot resolve yourself:

► Note the ID n u m ber

of your device. The ID number is found on the type rating

plate on the back,

the underside or the top of the casing.

► F o r further clariﬁcation of the problem, contact the Service Desk for your country (see the

Service Desk list o r visit the Internet at "

http://support.ts.fujitsu.com/contact/se rvicedesk"). When

you do this, please have ready the identity number and serial number of your system.

Troubleshooting

Power-on indicator does not light up after the

device is switched o n

Cause Corrective measure

The mains power supply is faulty. ► Ch eck whether the power cable is properly

plugged into the device and into a grounded

mains outlet.

► Switch the device on.

Internal power supply overloaded.

► Pull the

power plug for the device out of the

grounde

d mains outlet.

► Wait for a moment.

► Plug th

e power plug back into a grounded

mains

outlet.

► Switch the device on.

28 Fujitsu