Operation Manual

System expansions
Installing the plastic drive cover
Depending on the drive, e.g. if you wish to remove the accessible drive, you may
needtorefit the plastic drive cover again afterwards.
► Insert the drive cover in t he direction
of the arrow into the front panel
and press the latches lightly into the
corresponding brackets.
► Close the casing (see "
Closing the
casing", Page 30).
Installing and removing the drive cage
Removing the drive cage
Drivecage
► O pen the casing (see "Opening the casing", Page 29).
2
1
► Fold up the drive cage at an angle (1).
► If a drive is present, disconnect the
connector of the data and power supply
cables from the drive (2).
► Take out the drive cage from the
casing mounts.
34 A26361-K1002-Z220-1-7619, edition 2