Operation Manual

System expansions
Removing boards
► O pen the casing (see "Opening the casing", Page 29).
2
1
► If necessary, unplug any cables which
are connected to the board.
► Open the retaining clip (1).
► Remove the board out of the casing (2).
► If you do not want to install a new
board, reinstall the slot cover.
1
2
► Slide the slot cover downward into the
rear panel of the casing (1).
► Close the reta ining clip (2).
► Close the casing (see "
Closing the
casing", Page 30).
If you have installed or removed a PCI board, ch eck the relevant PCI
slot settings in the BIO S Setup. Change the settings as required. Further
information is provided in the PCI bo ard documentation.
32 A26361-K1002-Z220-1-7619, edition 2