Operation Manual

System expansions
Installing a board
Do not throw the slot cover away. If you r emove the board aga in, you
will need to install the slot cover again (cooling, fire protection or EMC
regulations which need to be complied with).
1
2
► O pen the casing (see "Opening the
casing", Page 29).
► O pen the retaining clip (1).
► Slide the slot cover upward out of
thecasing(2).
► Make the required settings on the board.
2
1
► Guide the board into the slot recess (1).
► Close the retaining clip (2).
► If necessary, connect the cables
to the mod ule.
A26361-K1002-Z220-1-7619, edition 2 31