Operation Manual

Getting started
Horizontal operating position with rubber/plastic f eet
HorizontaloperatingpositionOperatingposition, horizontalRubber/plasticfeet
The horizontal operating position is only p ermitted with the rubber/plastic
feet (due to the heat generated on the underside).
► If necessary, disconnect the cables.
► Place the device on its upper side on a sturdy, flat and clean surface.
► Stick the rubber/plastic feet (1) to the
underside of the casing.
► To ensure a that the device is stable,
the rubber/plastic feet should be fixed
in similar positions to the ones shown
in the illustration.
► Place the device on the rubber/plastic feet.
► If necessary, reconnect any cables tha t
were previously disconnected.
A26361-K1002-Z220-1-7619, edition 2 9