User's Manual
Table Of Contents
- FUJITSU Tablet STYLISTIC Q665
- Contents
- Declarations of conformity 7
- Fujitsu Contact Information 8
- Ports and controls 10
- Important notes 14
- First-time setup of your device 19
- Working with the Tablet PC 23
- Settings in BIOS Setup Utility 72
- Troubleshooting and tips 75
- Technical data 85
- Manufacturer’s notes 91
- Declarations of conformity 94
- FCC and IC Regulatory Information 95
- Appendix 99
- Index 114
- Fujitsu Shopping Online
- Maintaining Latest Configuration
- Limited Warranty
- Ports and controls
- Front (figure does not show the water-resistant device variant)
- Right side (top - water-resistant device variant, bottom - non water-resistant device variant)
- Additional safety notes for devices with wireless components
- Protecting the display screen
- Energy saving
- Traveling with your Tablet PC
- Waterproof/dustproof (device-dependent)
- Cleaning the Tablet PC
- Cleaning with disinfectant wipes
- Unpacking and checking the device
- Choose a location
- Connecting the AC adapter
- Switching on the device for the first time
- Switching the Tablet PC on
- Switching the Tablet PC off
- Handwriting recognition
- Touchscreen
- Select display orientation (portrait or landscape format)
- Using fingers
- Using the stylus
- Tablet buttons
- Webcam
- Rechargeable battery
- Using the energy saving functions
- Memory cards
- SIM card
- Ethernet and LAN (only with performance docking cradle)
- GPS
- Your performance docking cradle (optional)
- Keyboard docking station (optional)
- Intermediary VESA Mount Plate (optional)
- Hand strap (optional)
- Security functions
- Configuring the fingerprint sensor
- Using the Security Lock
- SmartCard reader (optional)
- Trusted Platform Module - TPM (device dependent)
- Connecting an external monitor
- Connecting USB devices
- Connecting external audio devices
- Settings in BIOS Setup Utility
- Starting the BIOS Setup Utility
- BIOS Setup Utility operation
- Exiting BIOS Setup Utility
- Exit Saving Changes - save changes and exit BIOS Setup Utility
- Exit Discarding Changes - Reject changes and exit BIOS Setup Utility
- Load Setup Defaults – load default values
- Discard Changes - Discard Changes without exiting BIOS Setup Utility
- Save Changes - save changes without exiting the BIOS Setup Utility
- Save changes and power off
- Executing a reset
- Help if problems occur
- Recovering your Factory Image
- The Tablet PC’s date or time is incorrect
- The printer does not print
- Acoustic warning
- WLAN specifications
- Rechargeable battery
- Keyboard docking station (optional)
- Cover (optional)
- DOC (Industry CANADA) Notices
- ENERGY STAR Compliance
Troubleshooting and tips
Error message/cause
Troubleshooting
CMOS battery bad
If the error message occurs repeatedly, the
buffer battery in the Tablet PC is flat.
► Contact your sales outlet or our customer
service center.
System CMOS checksum bad - Default configuration
used
The system configuration information is
incorrect.
► Switch the Tablet PC off.
► Switch the Tablet PC on.
► In the BIOS Setup, select the Exit menu.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory. an error
has resulted at the address xxxx.
► Contact your sales outlet or our customer
service center.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
► Start the BIOS Setup (Primary Master
submenu) and select the correct settings.
Keyboard controller error
► Switch your Tablet PC off with the ON/OFF
button.
► Wait 3 - 5 seconds and switch the Tablet PC
on agai
n.
Keyboard error
If you use an external keyboard:
► Check the connection and reboot the Tablet
PC.
nn Stuck key
► Make sure that no key is pressed.
Operating system not found
► Check in the BIOS Setup whether your hard
disk has been set correctly.
► Make sure that the operating system is
installed on
the corresponding drive.
Press <F1> to resume, <F2> to SETUP
This error message appears if an error occurs
during the self-test before starting the operating
system.
► Press the
Alt
tablet button to boot the
operating system
Real time clock error
► Contact your sales outlet or our customer
service center.
nnnnK Shadow RAM failed at offset: xxxx Failing
Bits: zzzz
► Contact your sales outlet or our customer
service center.
System battery is dead - Replace and run SETUP
► Contact your sales outlet or our customer
service center.
System cache error - Cache disabled
► Contact your sales outlet or our customer
service center.
System timer error
► Contact your sales outlet or our customer
service center.
84 Fujitsu