Technical data

Appendix
Determining whether Recovery and Utility is pre-loaded
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. U se the
Tab
key to get to the A pplication Menu.
3. C heck whether the Recovery and Utility option is present. If it is not present, it mean s
that the utility must be used from the Bootable Disk. Proceed to “Running Recovery and
Utility from the Bootable Disk” if Recovery and Utility is unavailable.
Running Recovery and Utility from hard disk
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. U se the
Tab
key to get to the A pplication Menu.
3. C ursor down to Recovery and Utility and p ress the
Enter
key.
4. C hoose y our language, if necessary. Select Recovery and Utility to proceed.
5. T hree tool options appe ar: Diagnostics, Recovery,andUtility (refer to the Recovery and
Utility tools section below for instructions on how to use t hese tools).
6. If this was successful please skip the next step and go to “Recovery and Utility tools.”
7. If this was NOT successful, p lease go to the next step.
Running Recovery and Utility from the Bootable disk
To verify/change the boot-up priority (rather than booting-up from the hard drive or
an external media drive), perform the following s teps:
1. Pow er o n your system. When the Fujitsu logo appears on the screen, press the
F12
key.
2. In sert the bootable disk into the drive tray.
3. H ighlight the CD/DVD option from the Boot menu, then press
Enter
.
4. Click OK.
5. Select CD/DVD boot mode: UEFI Mode, if applicab le, and then press
Enter
.
While the files are being loaded from the disk, the Fu jitsu logo screen will appear
followed by a progress bar at the bot tom of the screen.
96 Fujitsu