Technical data

Troubleshooting and tips
Error messages on the screen
Errormessages onthescreenErrors
This section describes the error messages generated by the BIO S Setup. Error messages displayed
by the operating system or programs are described in the d ocumentation for these programs.
If the error message appears repeatedly despite troubleshooting measures,
contact the place of purchase or our customer service c enter.
Error message/cause Troubleshooting
CMOS Battery Bad
If the e rror message occurs repeatedly, the
back-up battery in the notebook is dead.
Contact your sales outlet
or our customer
service center.
System CMOS checksum bad - Default conguration
used
The system conguration information is
incorrect.
Switch the notebook of
f.
Switch the notebook on.
Press the function k
ey
F2
to access the
BIOS Setup.
In the BIOS Setup, select the Exit menu.
Select the entry Lo
ad Setup Defaults.
Select OK and press the Enter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory. an error
has resulted at the address xxxx.
Check whether the add itional memory
module has been inserted correctly.
Failure Fixed Disk n
The s ettings of the hard disk drive are incorrect.
Start the BIOS Setup (Prim ary Master
submenu) and select the correct settings.
Keyboard controller error
Switch the n otebook off w ith the ON/OFF
button.
Wait 3 - 5 seconds and switch on the
notebook again.
Keyboard error
If you use an external keyboard:
Check the connect ion and reboot the
notebook.
nn Stuck key
Make sure that no key is pressed.
Operating system not foun d
Check
in the BIOS Setup whe ther your hard
disk h
as been set correctly.
Make sure that the operating system is
installed on the corresponding drive.
Press <F1> to resume, < F2> to SE TU P
This error message appears if an error occurs
during the self-test before starting the operating
system.
Press the
F1
function key to s tart the
operating system.
Press the function key
F2
to access the
BIOS Setup.
76 Fujitsu