User guide

Chapter 2 Components
> 2.2 2.5" Type Controller Enclosure
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
57
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
2.2 2.5" Type Controller Enclosure
The 2.5" type controller enclosure contains 2.5" disks installed in the front, and controller mod-
ules and power supply units (with fans) in the rear.
2.2.1 Front View
With flange cover
Figure 2.11 Front view of 2.5" type controller enclosure (with flange cover)
Flange cover
DISK FAULT LED
Glows orange ( ) when a disk has failed.
Blinks orange ( ) according to the VDS (Microsoft Virtual Disk Service) commands.
DISK READY LED
Glows ( ) or blinks green ( ) when disks
are operating normally.
Disk
Up to 24 disks can be installed in the ETERNUS DX60/DX80/DX90.
POWER LED
Glows green ( ) when the power is
turned on.
READY LED
Glows green ( ) when device is available
for use.
FAULT LED
Glows orange ( ) when an internal device
part abnormality has been detected.
Blinks orange ( ) when a device part which
needs preventive replacement has been
detected.
IDENTIFY LED
Blinks blue ( ) or turns off ( ) as ordered
via GUI to identify the enclosure installation
locations.
Power switch
Used to turn the device
ON and OFF.
CACHE LED
Glows green ( ) when there is data in the
device cache.
Blinks ( ) when a power failure has
occurred and the cache data is being saved
to flash memory.