User guide

Chapter 8 Installing Optional Products
> 8.2 Drive Enclosure Installation
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
191
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
8.2 Drive Enclosure Installation
This section describes how to install a drive enclosure in the ETERNUS DX60/DX80/DX90.
8.2.1 Drive Enclosure Handling Instructions
■ About condensation
■ About static electricity
■ About shock
CAUTION
Do
• When moving a drive enclosure from a cold place, such as an un-
conditioned store house in winter, to a warmer place such as an air-
conditioned room, the severe temperature change may result in
condensation forming.
To avoid this, allow the packed drive enclosures sufficient time in the
warmer place (one hour for each 15°C of temperature difference) to
adapt to the new temperature.
CAUTION
Do
• When handling the drive enclosure, make sure to wear a wrist strap.
Failure to discharge static electricity may cause device failure.
Do not remove it until the operation is complete.
CAUTION
D
o N
ot
• Do not handle the drive enclosure roughly or subject it to physical
shocks when laying it down.
• Do not stack the drive enclosures.
• Do not knock or drop the drive enclosure on hard objects.