User guide

Chapter 8 Installing Optional Products
> 8.1 Disk Installation
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
188
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
6-3 Swing the lock lever in the direction of the arrow, until the lock clicks shut.
6-4 Check that the newly installed disk’s DISK READY/FAULT LED lights up green after
approximately 30 seconds.
7 Repeat Step 5 and Step 6 for each additional disk.
8 Remove the wrist strap.
9 Re-attach the front cover.
For details on how to attach the front cover, refer to "3.3 Attaching and Removing the Front
Cover" (page 75).
10 On the Storage System Status screen of GUI, check that the added disks have
been recognized.
11 Set up RAID groups, volumes, hot spares, and Host Affinity settings on the new
disks, as required.
End of procedure
I
MPORTAN
T
Make sure that the lock lever hooks have engaged the slot
protrusions.
Lock lever
Hook
Slot
protrusion
Hook
Slot
protrusion
Lock lever hooks
have not engaged
Lock lever hooks
have engaged