User guide

Chapter 7 Setup
> 7.4 Monitoring Setup
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
173
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
5 Set the necessary items in the [Mail Server Settings] area.
Figure 7.35 [Setup E-Mail Notification] screen (Mail Server Settings)
6 After finishing the necessary settings, click the [Set] button.
A confirmation screen appears.
7 Click the [OK] button.
The specified send E-mail setting is registered.
8 Click the [Send Test E-mail] button to check that an E-mail can be sent to the
specified E-mail destination address.
Figure 7.36 Send Test E-mail
End of procedure
7.4.3 ServerView (SNMP Trap Notification) Setup
This section explains how to perform settings to monitor event notification (Trap) by SNMP using
"ServerView", when the ETERNUS DX60/DX80/DX90 is connected to the Industry standard
server PRIMERGY.
I
MPORTAN
T
• Use ServerView whose version is V3.60L20 or later.
• For the details on the Industry standard server side settings, refer to
"ServerView User's Guide" that is provided with the PC server.
Refer
"ServerView User's Guide"