User guide

Chapter 7 Setup
> 7.2 Basic Setup
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
154
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
A confirmation screen appears.
3-2 Click the [OK] button.
The volume is created, and the [Define Host] screen appears.
4 Set up the host.
Specify information for the server being connected to the ETERNUS DX60/DX80/DX90.
Setting screens will vary depending on the ETERNUS DX60/DX80/DX90 model.
■ For Fibre Channel
On the [Setup FC Host] screen, register the Fibre Channel card WWN for the server being
connected to the ETERNUS DX60/DX80/DX90.
(1)Click the [Add] button on the [Setup FC Host] screen.
(2)Specify a WWN, server name, and host response.
Figure 7.15 [Setup FC Host] screen
(3)Specify the other necessary items, and click the [Add] button.
The target FC host is displayed in the "Registered FC Host List" field.
(4)When adding another FC host, repeat Step (2) and Step (3).
If another FC host does not need to be added, click the [Done] button.
(5)Click the [Next >] button.
A confirmation screen appears.
(6)Click the [OK] button.
The settings are reflected and the [Configure Affinity Group] screen in Step 5
appears.
I
MPORTAN
T
When the Host Affinity function is not used, the host setting is not
required.
I
MPORTAN
T
When a FC switch is connected to the ETERNUS DX60/DX80/DX90,
settings for FC switch and the server (FC host) must be completed in
advance.