User guide

Chapter 7 Setup

> 7.2 Basic Setup

ETERNUS DX60/DX80/DX90 Disk storage system User Guide

149

P3AM-3042-06ENZ0

8 Finish the initial setup.

8-1 Click the [Finish] button.

Figure 7.11 [Finish] screen of the initial setup

The [Initial Setup] completes.

8-2 Remove the LAN cable (for operation management) from the PC, and connect the LAN

cable (for operation management) of the MNT port of Controller 1 (CM#1) and

Controller 0 (CM#0) to the customer's network.

8-3 Start the Web browser, and logon again with the new IP address to perform the config-

uration settings of the ETERNUS DX60/DX80/DX90 using Configuration Wizard.

End of procedure

7.2.2 Configuration Wizard

Perform the settings necessary for device operation using the [Configuration Wizard] menu on

the [Easy Setup] tab.

Perform the settings in the following order.

• Create RAID Group

• Create Volume

• Define Host

• Configure Affinity Group

• Define LUN Mapping

MPORTAN

Device setting operation cannot be continued if the IP address is

changed. Logon again with the new IP address is required.