User guide

Chapter 7 Setup
> 7.1 Setup Preparation
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
137
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
❏ IP address and subnet mask for the ETERNUS DX60/DX80/DX90's RMT port
No default value is set.
This setting is required if the remote support connection is to be independent of the customer
network.
When enabling the RMT port of a Slave CM for dual controller model, two IP addresses are
required.
❏ Gateway IP address
No default value is set.
❏ IP address for maintenance work
Prepare an IP address for maintenance work.
■ Completing and attaching the Network Settings label
Complete the network setting information in the provided Network Settings label and attach it on
the ETERNUS DX60/DX80/DX90.
❏ Completing the Network Settings label
Complete the following items in the Network Settings label.
- IP address of MNT port
IP address of the device MNT port
- IP address of FST
IP address for maintenance work
- Subnet Mask
Subnet mask of network connected
- IP address of RMT port
IP address of the device RMT port
I
MPORTAN
T
The ETERNUS DX60/DX80/DX90 can be reset to the factory default
network settings by pressing the Controller Enclosure's IP RESET
Switch twice in succession within a two second interval.