user manual

C141-E110-02N
xi
FIGURES
page
1.1 Current fluctuation (Typ.) when power is turned on............................................................ 1 - 7
2.1 Disk drive outerview ............................................................................................................ 2 - 1
2.2 1 drive system configuration ................................................................................................2 - 3
2.3 2 drives configuration........................................................................................................... 2 - 3
3.1 Dimensions........................................................................................................................... 3 - 2
3.2 Handling cautions................................................................................................................. 3 - 3
3.3 Direction............................................................................................................................... 3 - 4
3.4 Limitation of side-mounting.................................................................................................3 - 5
3.5 Mounting frame structure..................................................................................................... 3 - 5
3.6 Surface temperature measurement points............................................................................. 3 - 6
3.7 Service area .......................................................................................................................... 3 - 7
3.8 Connector locations.............................................................................................................. 3 - 8
3.9 Cable connections................................................................................................................. 3 - 9
3.10 Power supply connector pins (CN1)..................................................................................... 3 - 10
3.11 Cable configuration .............................................................................................................. 3 - 11
3.12 Cable type detection using CBLID- signal
(Host sensing the condition of the CBLID- signal).............................................................. 3 - 12
3.13 Cable type detection using IDENTIFY DEVICE data
(Device sensing the condition of the CBLID- signal) .......................................................... 3 - 12
3.14 Jumper location .................................................................................................................... 3 - 13
3.15 Factory default setting .......................................................................................................... 3 - 14
3.16 Jumper setting of master or slave device.............................................................................. 3 - 14
3.17 Jumper setting of Cable Select .............................................................................................3 - 15
3.18 Example (1) of Cable Select................................................................................................. 3 - 15
3.19 Example (2) of Cable Select................................................................................................. 3 - 15
4.1 Head structure....................................................................................................................... 4 - 2
4.2 MPG3xxxAT Block diagram................................................................................................ 4 - 5
4.3 Power-on operation sequence............................................................................................... 4 - 6
4.4 Block diagram of servo control circuit................................................................................. 4 - 12
4.5 Physical sector servo configuration on disk surface............................................................. 4 - 14
4.6 126 Servo frames in each track............................................................................................. 4 - 16
5.1 Execution example of READ MULTIPLE command.......................................................... 5 - 19
5.2 Read Sector(s) command protocol ....................................................................................... 5 - 77