Technical data

System upgrades

48 A26361-K1000-Z221-1-7619, edition 2

Installing and removing the floppy disk drive

► Open the casing (see "Opening the casing").

► Remove the data and power supply connectors from the floppy disk drive.

► Remove the screws (1) on the right side of the floppy disk drive.

► Slide the floppy disk drive out of the casing in the direction of the arrow (2).

► Slide the new floppy disk drive into the case opposite the direction of the arrow (2).

► Fasten the floppy disk drive with the screws (1).

► Fit the data and power supply connectors to the floppy disk drive. Make sure the polarity is

correct.

► Close the casing (see "

Closing the casing").

It may be necessary to modify the entry for the drive in the BIOS Setup.