Technical data

System upgrades
62 A26361-K994-Z220-1-7619, Edition 2
1
a
► Push the slot cover into the slot (1).
!
Ensure that the projection (a) on the slot cover engages into the appropriate recess. If it
does not, you will find it difficult to close the locking rail. There is a danger that damage
may be caused.
3
2
2
b
► Press the clips (2) from outside in the cut-outs on the case rear panel until the clips engage.
When doing so, make sure that you press the rail carrier (b) into the corresponding opening.
► Fold closed the locking slide (3).
► If you have removed the cross-piece, install it now (see "
Installing the cross-piece").
► Install the fan (see "
Installing the side fan").
► Close the casing (see "
Closing the casing").