User Manual

AN07-00180-3E
- 38 -
The message pane at the bottom of the window shows a message that tells no error was found as shown in
“Figure 2-4 Completing the build” to inform you of successful build.
Figure 2-4 Completing the build
2.1.2 Writing the program into the microcontroller
Preparation
Set MODE on the board to “PRG” in advance.
Select “Start” → “All Programs” → “FUJITSU FLASH MCU Programmer” → “MB91F267NA” to
activate PC Writer.
To select a file to be written as shown in “Figure 2-5 Opening the file to write”, click the “Open” button.
Figure 2-5 Opening the file to write
Click this.