User's Manual

47
The procedures are different depending on how you wear.
■Wear on the head
Please see “Assemble the fitting belt” (→P.46)
■Wear on a helmet
Please see “Attach to a helmet” (→P.52)
Assemble the fitting belt
Assemble the fitting belt to be attached to the inner side of this product.
The length of the belt can be adjusted at the end so please assemble it first as
explained below.
1 Attach belt attachments and head adjusters to the product.
Attach to the place where circled below.
<Below image shows how the belt attachments and head adjusters
are attached.>
The following explanation is how to attach the belt on this side(right side).
1. A single hook-and-loop fastener on the right belt attachment should
be touching the product and align the positioning holes.
Check to see if the positioning holes are aligned correctly.
If they are not aligned, unstick the hook-and-loop fastener on the back
of the belt attachment by pulling and align the holes.
After the holes are aligned, stick the hook-and-loop fastener.
Hook-and-loop fastener on the
back of the belt attachment by