User's Manual

33
Example: microUSB connector
□Rubber seals
The rubber seals around the caps are important to maintain
waterproofness/dustproofness. Note the following points.
●Do not remove or damage the rubber seals.
●When closing the cap, be careful not to let the rubber seals get caught.
Forcibly closing the cover with the rubber seals caught may damage them
resulting in loss of waterproofness/dustproofness.
●If any liquid other than fresh water and tap water (hot water, seawater,
detergent, chemical, sweat, etc.) at room temperature (5°C to 35°C) gets on
the product, it may cause deterioration in waterproofness/dustproofness.
●Do not open/close the cap with gloved hands. Do not get dust on the product.
A small particle (a hair, a grain of sand, fine fiber, etc.) on the seals could
cause water leakage. If small particles are attached to the product, make
sure to remove them with a clean dry cloth.
●Do not insert sharp objects into gaps of the cap. Doing so may damage the
rubber seals, causing water leakage.
●It is recommended to replace the rubber seals (charged service) for
maintaining waterproofness/dustproofness once every two years regardless
of whether any abnormality is present. For information on rubber seals
replacement, contact your local sales representative.
□When liquid other than water are attached on the product
If any liquid other than plain water (e.g. seawater, detergent, sand or mud)
attached on the product, immediately rinse it with plain water.
□After the product gets wet
If the product gets wet, drain water and wipe off water drops on the product
with a clean dry cloth.
* Do not leave the product without wiping off water. Doing so may
short-circuit the connector.