Operation Manual

Getting started
► Connect one of the connectors of the data cable to the D-SUB socket or the DVI-D socket or the
HDMI socket of the monitor and secure the plug connection by tightening the retaining screws.
The monitor automatically detects the input w hen only one signal source is connected.
► Insert one plug of the audio line in the AUDIO IN socket on the monitor
and ma ke sure it is properly engaged.
► Plug the power ca ble supplied into the power connector of the monitor.
► Plug the supplied USB cable into the U SB IN socket and the oth er end of
the cable into a USB socket of the computer.
Connect the USB keyboard and USB m ouse directly to the PC, as the USB connector
socket of the monitor is switched off in energ y-saving mode.
A lock (Kensington Lock) can be mounted in the security slot to p rotect the monitor
against theft. A Kensington lock is not supplied with the monitor.
Connecting cables to the computer
Information on the computer connections and interfaces is contained in the
operating manual for your computer.
► Connect the data cable to the (active) monitor port on the computer and secure
the plug-in connection by tightening the safety screws.
► Insert the othe r plug of the audio cable in the audio output of the computer.
► Plug the power connector of the monitor into a properly grounded mains outlet.
► Plug the power connector of the computer into a properly grounded mains outlet.
If your comp uter has two m onitor ports ("onboard" screen controller and separate
graphics card), the monitor port for the separate graphics card is active as standard.
18