Operation Manual

Important notes
• The device must only be operated in landscape mode (0°) and portrait mode (90°). The
control buttons are located in the m iddle of the bottom of the monitor in landscape mode
(0°) and at the left-hand side of the monitor in portrait mode (90 °).
• Store this manual close to the device. If you pass the device on to third
parties, you should pass this manual on with it.
• We recommend that you place your device on a durable, non-slip surfa ce. In view
of the ma ny different finish es and varnishes used on furniture, it is p ossible that the
feet of the device may mark the surface they stand on.
• To ensure sufficient ventilation, the air supply and air outlet openings of
the monitor must never b e blocked.
• The device must be connected to protective earth.
• To prevent possible hearing damage, do not listen at high volume levels for long periods.
• Warning for excessive sound pressure from earphones and headphones:
Excessive sound pressure from earphones and headphones can c ause hearing loss.
Adjustment of th e equalizer to maximum increases the earphones and headphones
output voltage and the refore the sound pressure level.
Power cable
Use the supplied power cable only.
Use the following guidelines if it is n ecessary to replace the original cable set.
• The female/male receptacles of the cord s et must meet IEC60320/CEE-22 requirements.
• The cable has to be HAR-certified or VDE-certified. The mark HAR or
VDE will appear on the outer sheath.
• For devices which are mounted on a de sk or table, type SVT or SJT cable se ts may be
used. For devices which sit on the floor, only SJT type cable sets may be used.
• The cable set must be selected according to the rated current for your d evice.
• If necessary, replace the original power cable with a regular grounded 3-core ma ins lead.
Transporting the device
Device,Transpo rtationRetransportation
Transport all parts separately in their original packaging or in a packaging w hich
protects them f rom knocks an d jolts, to the new site.
Do not unpack them until all transportation manoeuvres are comp leted.
If the device is brought from a cold environ ment into the room where it will be used,
condensation may occur. Before ope rating the device, wait until it is absolutely dry
and has reached approximately the sa me te mperature as the insta llation site.
8