Operation Manual

Getting started
Adjusting portrait format
The mo nitor can be rotated from h orizontal format (landscape mode) into
vertical format (portrait mode).
► G ra sp the monitor with both hands on the right and left edge of the casing, tilt the monitor
backwards, move it into th e highest position an d turn it clockwise until it is in the portrait position.
For you to be able to display the screen conten ts in portrait mode, your graphics card
will also need to support this function or you will need to use special software.
In the OSD menu you have the option of switching the OSD manually
from landscape mode to portrait mode (see "
Changing the monitor
settings using the OSD menu", Page 24).
To reset the monitor to landscape mode, the m onitor should be turned anti-clockwise.
The OSD display can be reset again in th e OS D menu.
Removing monitor base
Before you can use a swivel arm or a similar accessory, you must remove the monitor base.
The display surface is su sceptible to scratching!
1
2
► Switch off the monitor and pull the power
plug out of the po w er so cket.
► Lay the monito
r on its face on a soft surface.
► Disconnect all cables.
► Release the b
ase stand by moving the slider
in the direc t
ion of the arrow (1) and hold it
while liftin
g the complete base stand up (2).

Yo u can now mount a swivel arm or a
similar accessory in accordance with VESA
FPMPMI using a hole spacing of 100 mm.
For instructions on how to mount the swivel arm or a similar accessory, please
see the documentation for the swivel arm or similar accessory.
16 Fujitsu