Instruction Manual

En-3
■
Up/down airow direction
Comfortable airow spread to every corner of the room by the
wide up/down airow.
Change manually 1
⇄
2
⇄
3
⇄
4
Swing operation 1
⇄
4
NOTES:
• Do not adjust the louvers by hand. It could result in improper
operation. In this case, stop operation and restart. The louvers
should begin to operate properly again.
• Even if the airow direction is set, it may operate at a di󰀨erent
position in the following operation.
- at the start of the Heating operation (position 1)
- during the Automatic defrosting operation
- at the start of the Auto mode operation (position 1 or 4)
• When used in a room with infants, children, elderly or sick persons,
the air direction and room temperature should be considered
carefully when making settings.
5. TIMER OPERATIONS
5.1. On timer or O󰀨 timer
The On timer starts the operation at your desired time.
The O󰀨 timer stops the operation at your desired time.
NOTE: Depending on the remote controller, this function may not be
available.
5.2. Weekly timer
NOTE: This function is available only by the wired remote controller.
The Weekly timer enables you to set operation schedules up to 4 setting
for each day of the week.
Use the Day o󰀨 setting to switch o󰀨 timed operation for a selected day
in the coming week. Because all days can be set together, the weekly
timer can be used to repeat the timer settings for all of the days.
Temperature setting range
Auto, Cooling,
or Dry mode:
64-88 °F (18.0-30.0 °C)
*Even if you set to 50, 60-63 °F (10, 16.0–17.5 °C),
the air conditioner will run at 64 °F (18.0 °C).
Heating mode: 50 or 60-88 °F (10 or 16.0-30.0 °C)
• The operation modes will be the same as the mode at the last
time operation was stopped. So Cooling → Heating → Cooling →
Heating type of operations cannot be set automatically.
• If you set the On timer and O󰀨 timer on the same time, the On timer
will work.
• If two On timers are set on the same time, the air conditioner will run
in the order of the program number.
• You cannot the Weekly timer and the other timers simultaneously
If you use the On/O󰀨 timer, the Program timer, or the Sleep timer
while the Weekly timer is activated, the Weekly timer will be
deactivated.
In such a case, activate the Weekly timer after the other timer
nishes.
■
Dry mode
Use for gently cooling while dehumidifying your room.
NOTES:
• You cannot heat the room.
• Set the temperature lower than the current room temperature,
otherwise, the operation will not operate.
• The unit will operate at low speed in order to adjust room humidity.
The indoor unit’s fan may stop from time to time. Also, the fan may
operate at very low speed when adjusting room humidity.
• The fan speed cannot be changed manually.
■
Fan mode
Use to circulate the air throughout your room.
NOTES: You cannot set the temperature.
■
Heating mode
Use to warm your room.
NOTES:
• Set the temperature higher than the current room temperature.
• At the beginning of the operation, the indoor unit fan rotates at very
low speed for 3-5 minutes.
• The Automatic defrosting operation overrides the Heating operation
when necessary.
• After the start of Heating operation, it takes sometime before the
room gets warmer.
4. AIRFLOW SETTINGS
NOTES: For detailed instructions on how to operate, refer to the
operation manual of the remote controller.
4.1. Fan speed setting
The fan speed changes as follows.
When Auto is selected, the fan speed is automatically adjusted
according to the operation mode.
Heating: The fan will operate at very low speed when the
temperature of the air issued from the indoor unit is low.
Cooling: As the room temperature approaches the set
temperature, the fan speed becomes lower.
Fan: The fan runs at low speed.
The fan will operate at a very low speed during monitor operation and at
the start of the heating mode.
When Quiet is selected, Super Quiet operation begins. The indoor unit’s
airow will be reduced for quieter operation.
● The Super Quiet operation cannot be used during the Dry mode. (It
includes the Dry mode selected during the Auto mode operation.)
● During the Super Quiet operation, heating and cooling performance
will be reduced somewhat. If the room does not warm up/ cool down
when using the Super Quiet operation, adjust the indoor unit’s fan
speed.
4.2. Airow direction setting
You can set the following items.
• Up/down airow direction setting
• Swing operation setting (up/down)
NOTES: The Swing operation may stop temporarily when the indoor
unit fan is rotating at very low speed or is stopped.
Auto High Med Low Quiet