Specifications Sheet

Page 4 / 4 AH_PIS_ ASTG34KMTA
Specifications
Electrical
Power Requirement 240V – 1Ph – 50Hz Outdoor
Fuse Or Circuit Breaker (A) 32 Min Power Cable (mm²) 4.0
Interconnecting Cables 3+E
Compressor
Type
Hermetic × 1
Motor (W) 2200
Indoor Coil Outdoor Coil
Type
Copper Tube + Aluminium Fin
Type
Copper Tube + Aluminium Fin
Rows / Stages
Main: 3 × 28, Sub1: 1 × 6,
Sub2: 1 × 4
Rows / Stages
2 × 38
Fin Pitch (mm)
Main: 1.2, Sub: 1.4
Fin Pitch (mm)
1.30
Coating
Hydrophilic Coating
Coating
Blue Fin
Indoor Fan And Motor Outdoor Fan And Motor
Fan Type
Cross flow fan × 1
Fan Type
Propeller fan × 1
Motor (W)
80
Motor (W)
100
Refrigeration System
Refrigerant Type R32
Charge g 1650
Maximum Line Length / Height m 50 / 30
Pre-Charged Length m 30
Additional Charge g/m 45
Connection Method Flared
Expansion Control Electronic Expansion Valve
Safety Devices
T
ype of
protection
Protection form
Circuit protection
Current fuse (Near the terminal) 250 V, 25 A
Current fuse (Filter PCB) 250 V, 10 A
Current fuse (Main PCB) 250 V, 3.15 A
Fan motor
protection
Thermal protection
Activate
—
Reset
—
Thermistor protection
Activate
More than 80 °C, Fan motor speed down
Reset
80 °C or less, Fan motor speed recover
Compressor
protection
Terminal protection
program (Compressor
temp.)
Activate
120 °C, Compressor stop
Reset
80 °C, Compressor restart
Thermal protection
program (Discharge
temp.)
Activate
110°C, Compressor stop
Reset
After 7 minutes, Compressor restart
High pressure
protection
Pressure switch
Activate
4.2±0.1 MPa, Compressor stop
Reset
3.2±0.15 MPa, Compressor restart
Low pressure
protection
Pressure sensor
Activate
0.12 MPa, Compressor stop
Reset
0.15 MPa, Compressor restart
* Specifications and design are subject to change without notice. Please check with your dealer.
FUJITSU GENERAL (AUST) PTY LIMITED
ACN 001 229 554
A SUBSIDIARY OF FUJITSU GENERAL LIMITED
HEAD OFFICE:
SYDNEY : [phone]
MELBOURNE : [phone]
BRISBANE : [phone]
ADELAIDE : [phone]
PERTH : [phone]
HOME PAGE
www.fujitsugeneral.com.au