Operating instructions

En-4
To set the operation mode
● Operation mode setting
● Room temperature setting
● Fan speed setting
Temperature setting range
COOL ................................................ 18 to 30 °C
* HEAT ................................................ 16 to 30 °C
Lower Rise
Press the MODE button to set the operation mode.
Press the SET TEMP. buttons to set the room temperature.
Press the FAN button to set the fan speed.
About Mode Operation
*Heating
● Always set the temperature higher than the current room temperature. If it is set lower than the current room temperature, heating
will not start.
● For about 3 to 5 minutes after starting heating, the fan will operate very slowly, then switch to the selected fan setting. This period
allows the indoor unit’s heat- exchanger to perform before emitting warm air.
● During defrosting (see page 9), the heating mode will be temporarily interrupted. The defrost indicator will turn on the remote controller
display.
Cooling
● Always set the temperature lower than the current room temperature. If it is set higher than the current room temperature, the unit
will not enter the cooling mode and only the fan will operate.
Fan
● The room temperature cannot be adjusted in the FAN mode. (The room temperature is not displayed on the remote controller.)
COOL FAN * HEAT
HIGH MED LOW
9365751053_OM.indb 49365751053_OM.indb 4 28-Mar-18 11:37:3328-Mar-18 11:37:33