Operating instructions

En-10
ECONOMY OPERATION
Begin air conditioner operation before performing this procedure.
To Use the ECONOMY Operation
Press the ECONOMY button.
The ECONOMY indicator will light.
ECONOMY operation begins.
To Stop the ECONOMY Operation
Press the ECONOMY button again.
The ECONOMY indicator will go out.
Normal operation begins.
About ECONOMY Operation
At the maximum output, ECONOMY operation is approximately 70% of normal air conditioner operation for cooling and heating.
●
If the room is not cooled (or heated) well during ECONOMY operation, select normal operation.
●
During the monitor period in the AUTO mode, the air conditioner operation will not change to ECONOMY operation even if
ECONOMY operation is selected by pressing the ECONOMY operation button.
●
When ECONOMY operation mode is operated, the room temperature will be little higher than the set-temp under cooling mode
and lower than set-temp under heating mode. Therefore, the ECONOMY mode is able to save more energy than other normal
mode.
Press the ECONOMY button for more than 2 seconds to select
whether the room temperature is detected at the indoor unit or
the remote controller.
When the
thermo sensor indicator appears, the room
temperature is detected at the remote controller.
NOTES
• If this function is locked, the location where the room temperature is detected cannot be changed and the mark fl ashes
when the ECONOMY button is pushed for 2 seconds or more.
Indoor unit
Room temperature sensor selection
SENSOR SETTING
•
This function is locked at the factory. In order to detect the room temperature correctly, consult authorized ser-
vice personnel when using this function.
9374379781-03_OM.indb Sec1:109374379781-03_OM.indb Sec1:10 8/6/2018 2:37:28 PM8/6/2018 2:37:28 PM