ASU12RL2 Installation Manual

En-12
Front panel installation
(1) Firstly, fi t the lower part of the front panel, and insert top
and bottom hooks. ( 3 top sides, 6 bottom sides)
Bottom holes
Bottom hooks
Top hooks
Top holes
Indoor unit
Front panel
(2) Three screws is attached.
(3) The wire cover is attached.
(4) The intake grille is attached.
CAUTION

Install the Front panel and Intake grille securely. If
installation is imperfect, the Front panel or Intake grille
may fall off and cause injury.
10. TEST RUN
Check items
(1) Is operation of each button on the remote controller unit
normal?
(2) Does each lamp light normally?
(3) Do airfl ow direction louvers operate normally?
(4) Is the drain normal?
(5) Do not have an abnormal noise and vibration during
operation?
• Do not operate the air conditioner in test run for a long time.
[Operation method]
• For the operation method, refer to the operating manual.
• The outdoor unit, may not operate, depending on the room
temperature. In this case, keep on pressing the MANUAL
AUTO button of the indoor unit for more than 10 seconds.
The OPERATION indicator lamp (green) and TIMER indicator
lamp (orange) will begin to fl ash simultaneously during
cooling test run. Then, heating test run will begin in about
3 minutes when HEAT is selected by the remote control
operation. (Please follow the operating manual for remote
control operation.)
(When the air conditioner is running by pressing the test run
button, the OPERATION indicator lamp and TIMER indicator
lamp will simultaneously fl ash slowly.)
• When ending the test run, keep on pressing the MANUAL
AUTO button of the indoor unit for more than 3 seconds.
11. REMOTE CONTROLLER
INSTALLATION
CAUTION
• Check that the indoor unit correctly receives the signal
from the remote controller, then install the remote con-
troller holder.
• Select the remote controller holder selection site by
paying careful attention to the following:
Avoid places in direct sunlight.
Select a place that will not be affected by the heat from
a stove, etc.
11.1. Remote controller holder
installation

Install the remote controller a maximum distance of 7 m
(23 ft) from the remote control receiver. However, when
installing the remote controller, check that it operates cor-
rectly.

I nstall the remote controller holder to a wall, pillar, etc. with
the tapping screw.
remote controller
holder fi xing
Remote controller
holder
Tapping
screw
(small)
remote controller
mounting
Remote
controller
2
Push
1
Set
9332622027_IM.indb 129332622027_IM.indb 12 2012-9-29 8:36:542012-9-29 8:36:54