ASU12RL2 Installation Manual

En-11
8. FINISHING
(1) Insulate between pipes.
• For rear, right, and bottom piping, overlap the connection
pipe insulation and indoor unit pipe insulation and bind
them with vinyl tape so that there is no gap.
• For left and left rear piping, butt the connection pipe
insulation and indoor unit pipe insulation together and
bind them with and vinyl tape so that there is no gap.
• For left and left rear piping, wrap the area which
accommodates the rear piping storage section with
cloth tape.
• For left and left rear piping, bind the connection cord to
the top of the pipe with vinyl tape.
• For left and left rear piping, bundle the piping and drain
hose together by wrapping them with cloth tape over
within the range of which they fi t into the rear piping
storage section.
(2) Temporarily fasten the connection cord along the
connection pipe with vinyl tape. (Wrap to about 1/3 the
width of the tape from the bottom of the pipe with tape so
that water does not enter.)
(3) Fasten the connection pipe to the outside wall with
saddles, etc.
(4)
Fill the gap between the outside wall pipe hole and the pipe
with sealant so that rain water and wind cannot blow in.
(5) Fasten the drain hose to the outside wall, etc.
Pipe
Saddle*
Outside wall cap*
Sealer
putty*
(Outdoors)
*Field supplied
Wall
Overlap the insulation
Bind the pipes together
so that there is no gap.
Connection pipe
(heat insulation)
Vinyl tape
Wrap with
cloth tape
Pipe
Drain hose
Cloth tape
Left piping
Connection cable
Pipe
Drain hose
For connection from the left rear
Connection cable
Wall pipe
Connection pipe
Drain hose
Check the following:
GOOD
Lifted up
Wave End in water
Prohibited
Prohibited
Prohibited
Drain hose
Saddle
9. FRONT PANEL REMOVAL AND INSTALLATION
Intake grill removal
Open the intake grille. While gently
pressing the left and right mounting
shafts of the intake grille outward “a”,
remove the intake grille in direction of the
arrow “b”.
Intake grill installation
While holding the grille horizontal,
set the leftand right mounting shafts
into the pillow blocks at the top of the
panel “c”.
To latch each shaft properly, insert the
shaft until it snaps.
Press 4 places on the intake grille to
close it completely.
Front panel removal
(1) Remove intake grille (Reference the intake grille removal.)
(2) Remove wire cover.
(3) Remove 3 screws.
Screws (Wire cover)
Screws (3 position)
Wire cover
(4) The front panel is pulled to the front, raising the upper
surface, and a front panel is removed.
b
a
c
9332622027_IM.indb 119332622027_IM.indb 11 2012-9-29 8:36:532012-9-29 8:36:53