Operating Manual

Table Of Contents
System expansions
36
A26361-K515-Z100-1-7619
Installing a board
!
Observe the notes on installing and removing boards in the chapter "Important notes".
Old ISA boards which require a 5 V power supply are not supported.
You can install boards which are up to 300 mm long.
The number, position and arrangement of the board slots on system board can be found in the
technical manual for the system board. Boards may be installed when the device is shipped.
1
2
3
4
²
Remove the screw (1).
²
Remove the rear slot cover plate from the slot (2).
!
Do not dispose of the rear slot cover plate. For cooling, protection against fire and in order
to comply with EMC regulations, you must refit the rear slot cover plate if you remove the
board.
²
Take the new board out of its packaging.
²
Make the required settings for the board.
Put the board in the required slot and push it carefully in place (3). Ensure that the end of a long
board without angle bracket fits into the corresponding guide of the system unit.
²
Press the board into the slot so that it engages.
²
Fix the board with the screw (4).
²
If necessary, plug the lines on the board.