Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Troubleshooting and tips
- Installing new software
- Power-on indicator remains dark after you have switched on your device
- The screen stays blank
- Flickering or drifting stripes on the monitor screen
- No mouse pointer displayed on the screen
- The floppy disk cannot be read or written
- Time and/or date is not correct
- Error messages on the screen
- Restoring the hard disk contents
- Tips
- System expansions
- Technical data
- Index
System expansions
32
A26361-K515-Z100-1-7619
²
Close the system unit (see "Assembling the system unit").
If necessary, you must adapt the entry for the drive in the Setup menu.
Replacing the hard disk or floppy disk drive
²
Open the system unit (see "Opening the system unit").
Removing the drive carrier
2
1
3
²
Press the unlocking device in the direction of the arrow (1).
²
Swivel the drive carrier in direction of the arrow (2).
²
Remove the drive carrier in direction of the arrow (3).