Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Troubleshooting and tips
- Installing new software
- Power-on indicator remains dark after you have switched on your device
- The screen stays blank
- Flickering or drifting stripes on the monitor screen
- No mouse pointer displayed on the screen
- The floppy disk cannot be read or written
- Time and/or date is not correct
- Error messages on the screen
- Restoring the hard disk contents
- Tips
- System expansions
- Technical data
- Index
System expansions
A26361-K515-Z100-1-7619
31
Installing an accessible drive
²
Open the system unit (see "Opening the system unit").
1
2
²
Lever out the plastic drive cover off the casing (1).
²
Pull the metal cover forward (2).
!
If you remove the drive again later, you will have to reinstall the covers.
²
Make the required settings on the drive (if necessary, on installed drives as well).
1
2
3
2
²
Slide the drive into the system unit (1).
²
Fasten the drive with the screws (2).
²
Plug the connectors of the data cable and the power supply cable into the drive (3).