Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Troubleshooting and tips
- Installing new software
- Power-on indicator remains dark after you have switched on your device
- The screen stays blank
- Flickering or drifting stripes on the monitor screen
- No mouse pointer displayed on the screen
- The floppy disk cannot be read or written
- Time and/or date is not correct
- Error messages on the screen
- Restoring the hard disk contents
- Tips
- System expansions
- Technical data
- Index
A26361-K515-Z100-1-7619
3
Important notes
In this chapter you will find information regarding safety which it is essential to take note of when
working with your PC. The manufacturer's notes contain helpful information on your PC.
Safety
!
Pay attention to the information provided in the manual "Safety and Ergonomics".
•
During installation and before operating the device, observe the instructions on environmental
conditions in the chapter entitled "Technical data
" as well as the instructions in the chapter
"Preparation for use and operation
".
•
Please check whether the device is set to the local power supply (see chapter "Preparation for
use and operation").
•
The On/Off switch does not separate the system unit completely from the line voltage. To
disconnect the line voltage completely, remove the power plug from the grounded power outlet.
•
When cleaning the device, observe the relevant notes in the paragraph "Cleaning the PC".
•
When connecting and disconnecting cables, observe the relevant notes in the chapter
"Preparation for use and operation
".
•
Replace the lithium battery on the system board in accordance with the instructions in the
chapter "System expansions
- Memory, processor, lithium battery".
•
Caution: components on the system board can get very hot.
•
Keep this Operating Manual together with your device. If you pass on the device to third
parties, you should also pass on this manual.