Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Troubleshooting and tips
- Installing new software
- Power-on indicator remains dark after you have switched on your device
- The screen stays blank
- Flickering or drifting stripes on the monitor screen
- No mouse pointer displayed on the screen
- The floppy disk cannot be read or written
- Time and/or date is not correct
- Error messages on the screen
- Restoring the hard disk contents
- Tips
- System expansions
- Technical data
- Index
A26361-K515-Z100-1-7619
29
System expansions
!
It may be necessary to update the BIOS when carrying out a system expansion or
hardware upgrade. In this instance, please contact our service.
This chapter describes all the activities required to modify your PC hardware (e.g. installing boards
or drives).
Memory and processor upgrading are described in the Technical Manual for the system board.
Read the supplied documentation before installing new drives and/or boards.
Refer to the Technical Manual for the system board before making any extensions on the system
board.
Opening the system unit
!
Please take note of the safety information in the chapter "Important notes".
Pull the power plug out of the power outlet!
2
1
1
a
²
If any cables attached to the system unit
are obstructing you, pull out the connectors
on the system unit.
²
Place the system unit in a convenient
working position.
²
Loosen the screws (1).
²
Pull the casing in the direction of the
arrow (2) until the distance (a) is
approximately 10 mm.
²
Lift the casing in an upward direction.