Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Troubleshooting and tips
- Installing new software
- Power-on indicator remains dark after you have switched on your device
- The screen stays blank
- Flickering or drifting stripes on the monitor screen
- No mouse pointer displayed on the screen
- The floppy disk cannot be read or written
- Time and/or date is not correct
- Error messages on the screen
- Restoring the hard disk contents
- Tips
- System expansions
- Technical data
- Index
Connecting the PC to the line voltage Preparation for use and operation
A26361-K515-Z100-1-7619
15
Connecting the PC to the line voltage
100 V - 125 V
200 V - 240 V
²
Check the rated voltage.
!
115 = 100 V to 125 V 230 = 200 V to 240 V
If the rated voltage does not agree with the local line voltage, you must move the wiper
switch to the correct position.
1
2
²
Plug the system unit's power cable into the system unit (1) and then into the grounded power
outlet (2).