User Manual

System expansions Installing and removing drives
38 A26361-K622-Z100-1-7619
Ê Removetheprotectionshield(4).
i
Do not throw away the covers. For cooling, protection against fire and in order to comply
with EMC regulations, you must refit the covers if you remove the drive again later.
A
A
B
B
A = Position of screw for non-accessible drive
B = Position of screw for accessible drive
Ê Take the new drive out of its packaging.
Ê Push the drive into the bracket and secure it with four screws.
2
1
Ê Push the bracket into the system unit until it snaps into place (1).
Ê Plug the connectors of the data cable and the power supply cable into the drives (2). Make sure
the polarity is correct.
Ê Close the system unit (see "Assembling the system unit").
i
If necessary, you must adapt the entry for the drive in the Setup menu.