User Manual

Installing and removing drives System expansions
A26361-K622-Z100-1-7619 37
2
1
Ê Push the carrier (1) into the system unit until it snaps into place.
Ê Plug the data and the power supply connectors into the floppy disk drive (2). Make sure the
polarity is correct.
Ê Close the system unit (see "Assembling the system unit").
i
If necessary, you must adapt the entry for the drive in the Setup menu.
Installing a second 3 1/2-inch drive
Ê Open the system unit (see "Opening the system unit").
1
2
3
3
Ê Pull the data and the power supply connectors from the floppy disk drive (1).
Ê Press on the spring (2) that holds the bracket in place at the top.
Ê Pull out the bracket (3).