User Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
System expansions Installing and removing drives
40
A26361-K516-Z100-3-7619
Removing the second hard disk drive
1
1
1
2
Remove the screws (1).
Pull the hard disk drive out of the
carrier (2).
Make the required settings on the
remaining hard disk drive
(e.g. stand alone).
Installing the hard disk carrier
1
2
Plug the data and the power supply connectors into the hard disk drive or into the hard disk
drives.
Push the drive carrier into the system unit in the direction of the arrow (1).
Swivel the drive carrier in the direction of the arrow (2) until it clicks into position. Please ensure
that the guide rail is in the groove.
Close the system unit (see "Assembling the system unit").
i
If necessary, you must adapt the entry for the drive in the Setup menu.