User Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
System expansions Installing and removing drives
38
A26361-K516-Z100-3-7619
Installing or removing the hard disk drive
Open the system unit (see "Opening the system unit").
Removing the hard disk carrier
Pull the data and power supply connectors from the hard disk drive or the hard disk drives.
3
2
1
Press the unlocking device in the direction of the arrow (1).
Swivel the drive carrier in the direction of the arrow (2).
Remove the drive carrier in direction of the arrow (3).
Installing the first hard disk drive
Take the new hard disk drive out of its packaging.
Make the required settings (e.g. master-slave settings) on the drive.
3
2
2
1
Insert the hard disk drive into the plastic bracket (1). The drive must engage in the plastic
nipple.
Fold the plastic bracket in the direction of the arrow (2) on the hard disk drive.
Push the hard disk drive into the drive bracket until the plastic bracket engages (3).