User Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
Installing and removing drives System expansions
A26361-K516-Z100-3-7619
37
Changing the floppy disk drive
Open the system unit (see "Opening the system unit").
2
3
1
Pull the data and the power supply connectors from the floppy disk drive (1).
Remove the screw (2).
Take the drive out of the system unit (3).
Take the new floppy disk drive out of its packaging.
3
1
2
Slide the drive into the system unit (1).
Plug the data and the power supply connectors into the floppy disk drive (2).
Fasten the drive with the screw (3).
Close the system unit (see "Assembling the system unit").
i
If necessary, you must adapt the entry for the drive in the Setup menu.